comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Plotting surfaces
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Plotting surfaces [message #11577] Fri, 17 April 1998 00:00
Jose Miguel Prellezo is currently offline  Jose Miguel Prellezo
Messages: 1
Registered: April 1998
Junior Member
I have an ASCII file with 3 columns, which represent the x, y, z samples
of a non-uniform grided surface. There are about 1500 points. How can I
plot the surface with IDL ?

I tried KRIG2D, but it's too slow.

Thank you for any tip!

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Global variables and command line
Next Topic: Ranting and Raving, Was: Global variables and command line

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Oct 10 11:44:30 PDT 2025

Total time taken to generate the page: 0.71923 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software