comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Offset surface plots
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Offset surface plots [message #122] Wed, 17 April 1991 11:09
oughton is currently offline  oughton
Messages: 3
Registered: February 1991
Junior Member
've been trying to figure out how to produce two surface plots
on the same page but offset from each other. I thought that this
could be done with the "t3d" procedure and the translate keyword.
However, I've been unable to get this to work. Does anybody have
any ideas/knowledge about what is required?

VMS 5.4-1, idl 2.0.13

Thanks, Sean.!:

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Bug in SunOS 4.1.1 affects IDL
Next Topic: window resizing & plotting

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Oct 11 02:20:57 PDT 2025

Total time taken to generate the page: 0.47653 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software