comp.lang.idl-pvwave archive: archive » Re: contours and Z device

Home » Public Forums » archive » Re: contours and Z device

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: contours and Z device [message #12224 is a reply to message #12221]

Fri, 03 July 1998 00:00

davidf
Messages: 2866
Registered: September 1996

Senior Member

rbianconi@my-dejanews.com (rbianconi@my-dejanews.com) writes:

> Hello, this little program attached works (under NT and Linux) with IDL
> 4.0.1, but not with IDL 5.0.2. It seems that when you are using the Z device
> and you ask the routine to plot a contour above the maximum value of your
> data, then an error occours in version 5.0.2. Instead, it works fine with
> vesion 4.0.1. Any comment ?

I get no error from this program in IDL 5.1 on Windows NT 4.0.

David
--
David Fanning, Ph.D.
Fanning Software Consulting
E-Mail: davidf@dfanning.com
Phone: 970-221-0438
Coyote's Guide to IDL Programming: http://www.dfanning.com/

Report message to a moderator

[Message index]

		Re: contours and Z device By: Vap User on Wed, 08 July 1998 00:00
		Re: contours and Z device By: rbianconi on Tue, 07 July 1998 00:00
		Re: contours and Z device By: rbianconi on Tue, 07 July 1998 00:00
		Re: contours and Z device By: dlhopols on Mon, 06 July 1998 00:00
		Re: contours and Z device By: davidf on Fri, 03 July 1998 00:00

Previous Topic:	Attention PV-WAVE Users - Announcing the IDL Trade Up Program!
Next Topic:	Voronoi diagram

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 01:08:42 PDT 2025

Total time taken to generate the page: 1.83870 seconds