comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » IDL crashes under MS Windows 3.1
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
IDL crashes under MS Windows 3.1 [message #1265] Thu, 19 August 1993 02:41
<HILTBRUNNER is currently offline  <HILTBRUNNER
Messages: 1
Registered: August 1993
Junior Member
Hi folks

I'm are running IDL 3.0.1 under Windows 3.1 on a 486-50DX with 16 MB RAM and
MS-DOS 5.0. I have the following problem with some (but not all) procedures:
If I want to run the compiled procedure (compiling gave no problem)
immediately after having started IDL, Windows reports a "protection violation
in module IDL.EXE at 0001:A4F4" error and IDL stops. The only way to make the
procedure run is to compile a different procedure first and to run it
afterwards. In this case everything works just fine.
I think there is nothing special with the mentioned procedures (memory used
and so on). They read some timeseries data from harddisk and plot them on
screen or to a postscript file.

Any suggestions? Thanks in advance

Dan

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Re: * looking for power fit
Next Topic: Bug in IDL routines VERONOI or TRIANGULATE ?!

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 15:36:33 PDT 2025

Total time taken to generate the page: 0.00467 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software