comp.lang.idl-pvwave archive: archive » Re: 100 user units to correspond to exactly 2 cm on the hard copy

Home » Public Forums » archive » Re: 100 user units to correspond to exactly 2 cm on the hard copy

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: 100 user units to correspond to exactly 2 cm on the hard copy [message #12774]

Thu, 03 September 1998 00:00

davidf
Messages: 2866
Registered: September 1996

Senior Member

Kristian Kjaer (kristian.kjaer@risoe.dk) writes:

> On a hard-copy (postscript) plot, how does one get the plot window (the
> area inside the box, where the data points roam) to be, say, precisely
> 10 by 12 cm?

Set_Plot, 'PS'
Device, XSize=10/0.8, YSize=12/0.8, XOffset=4.0, YOffset=6
Plot, Findgen(101), Position=[0.1, 0.1, 0.9, 0.9]

Cheers,

David
----------------------------------------------------------
David Fanning, Ph.D.
Fanning Software Consulting
E-Mail: davidf@dfanning.com
Phone: 970-221-0438, Toll-Free Book Orders: 1-888-461-0155
Coyote's Guide to IDL Programming: http://www.dfanning.com/

Report message to a moderator

[Message index]

Re: 100 user units to correspond to exactly 2 cm on the hard copy

By: davidf on Thu, 03 September 1998 00:00

Previous Topic:	volume measure
Next Topic:	100 user units to correspond to exactly 2 cm on the hard copy

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 22:53:20 PDT 2025

Total time taken to generate the page: 1.03844 seconds