comp.lang.idl-pvwave archive: archive » Q: How to delete 'active' procedure?

Home » Public Forums » archive » Q: How to delete 'active' procedure?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Q: How to delete 'active' procedure? [message #1297]

Wed, 11 August 1993 07:13

zagar
Messages: 5
Registered: December 1992

Junior Member

I've been getting very frustrated with IDL lately. I keep having to
quit & re-start pv-wave because I can't DELPROC my procedures after they've
been used.

When I just compile a procedure, I can delete it, but if I use the procedure
it becomes an 'active' procedure and DELPROC refuses to delete it.

I'd like to be able to write a procedure, test it, fix a bug,
and test it again without having to quit & re-start pv-wave.

Any comments on how that's done ?

-Randy

---

____________________________________________________________ ________________
/ \
| Randy Zagar The only time I open my mouth |
| Internet: zagar@Chester.CMS.UDel.Edu is to change feet. |
| Bell-net: 302/831-1139 -Ron Shapiro |
\___________________________________________________________ _________________/

Report message to a moderator

Previous Topic:	PV-Wave on Solaris 2.2
Next Topic:	Answer: How to delete 'active' procedure?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 03:12:10 PDT 2025

Total time taken to generate the page: 0.00745 seconds