comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » printer setup
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
printer setup [message #16441] Tue, 27 July 1999 00:00
lsyrkin is currently offline  lsyrkin
Messages: 9
Registered: May 1999
Junior Member
I have a Postscript Declaser 2250 printer connected to the printserver.
It was set up on Sun with logic name 'lp0'. I can print from any Unix
application using command 'lp -d lp0'. When I specify the same command
under IDLDE Print Setup (port lp0=lp -d lp0 for Digital DEClaser 2250)
it never prints. I have to save file as xprinter.eps and then print.

How can I set up my printer to make it print from File->Print?

Thanks in advance,

Leonid Syrkin.


Sent via Deja.com http://www.deja.com/
Share what you know. Learn what you don't.

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Re: combine 2 row-vectors to a matrix
Next Topic: idlwave mode for emacs/xemacs?

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 17:57:46 PDT 2025

Total time taken to generate the page: 0.00466 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software