comp.lang.idl-pvwave archive: archive » Y axis where Z axis is by default w/ surface

Home » Public Forums » archive » Y axis where Z axis is by default w/ surface

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Y axis where Z axis is by default w/ surface [message #17526 is a reply to message #17382]

Fri, 15 October 1999 00:00

davidf
Messages: 2866
Registered: September 1996

Senior Member

David Fanning (davidf@dfanning.com) writes:

> Once you have the 3D transportation matrix the way you
> want it, you apply it to the SURFACE command by setting
> the T3D keyword there. But nothing I do can get what
> you want.

Got the airline schedule on the brain. Of course,
"transportation matrix" should have been "transformation
matrix". Holy moly!

David

--
David Fanning, Ph.D.
Fanning Software Consulting
Phone: 970-221-0438 E-Mail: davidf@dfanning.com
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Toll-Free IDL Book Orders: 1-888-461-0155

Report message to a moderator

[Message index]

		Y axis where Z axis is by default w/ surface By: T Bowers on Thu, 14 October 1999 00:00
		Re: Y axis where Z axis is by default w/ surface By: T Bowers on Mon, 18 October 1999 00:00
		Re: Y axis where Z axis is by default w/ surface By: davidf on Fri, 15 October 1999 00:00

Previous Topic:	3D region growing
Next Topic:	??% TRIGRID: X, Y, or Z array dimensions are incompatible?? what the....

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Dec 02 09:01:39 PST 2025

Total time taken to generate the page: 0.80013 seconds