comp.lang.idl-pvwave archive: archive » Re: contour plot with y-x axis switch?

Home » Public Forums » archive » Re: contour plot with y-x axis switch?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: contour plot with y-x axis switch? [message #18358]

Mon, 20 December 1999 00:00

davidf
Messages: 2866
Registered: September 1996

Senior Member

Bob Stockwell (dejastockwell@my-deja.com) writes:

> A simple question,
>
> I have an array = (10,5000) for instance.
> I would like to lot the contour of this array,
> like so:
>
> contour,transpose(array)
>
>
> This is fine, but is it possible to
> avoid the tranpose operation and directly
> draw the contour plot with the x and y
> directions switched?

I'm quite sure that if there *was* a way (I don't
think there is) it would require even more keystrokes
than this. :-)

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting
Phone: 970-221-0438 E-Mail: davidf@dfanning.com
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Toll-Free IDL Book Orders: 1-888-461-0155

Report message to a moderator

[Message index]

Re: contour plot with y-x axis switch?

By: davidf on Mon, 20 December 1999 00:00

Previous Topic:	Page Size of HP-GL Device
Next Topic:	Re: Tip: how to mix object gui with command line

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 21:55:43 PDT 2025

Total time taken to generate the page: 1.19854 seconds