comp.lang.idl-pvwave archive: archive » contour plots -> array?

Home » Public Forums » archive » contour plots -> array?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

contour plots -> array? [message #18761]

Thu, 27 January 2000 00:00

egraves
Messages: 9
Registered: January 2000

Junior Member

I would like to obtain the results of a contour plot (obtained using the CONTOUR
procedure) in the form of a 2D array. I could plot the contours to a blank window and
then use TVRD to read an array from the display, but i was wondering if there is any
more convenient method of achieving the same result. Perhaps using the PATH keywords
to CONTOUR and using the contour path information to plot directly on an array?

Any help is appreciated!

Ted Graves
Magnetic Resonance Science Center
University of California, San Francisco

Report message to a moderator

Previous Topic:	Re: contour plots -> array?
Next Topic:	linux XF86 X visuals, IDL 16-bit blues

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:47:01 PDT 2025

Total time taken to generate the page: 0.00580 seconds