comp.lang.idl-pvwave archive: archive » conversion from IDL v1

Home » Public Forums » archive » conversion from IDL v1

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

conversion from IDL v1 [message #1927]

Tue, 05 April 1994 11:22

stpat
Messages: 2
Registered: April 1994

Junior Member

Hi. I am in the process of upgrading programs from Version
1, and am a bit confused by what has happened to !IGNORE.
The manual says to use /NOCLIP, but describes it as
turning on and off clipping. The reason I was using IGNORE
was because of the annoying way the vectors were altered
if points fell outside the plot axes. But, if I understand the
manual correctly, now clipping is done, which I interpret
to mean that the vectors aredrawn correctly inside the
plot axes. Is my interpretation correct? And, the NOCLIP
for the XYOUTS procedure is different from the NOCLIP
for the PLOT procedure (i.e., opposite)? Thanks for
your help!!!

Patti Twigg
stpat@lepvax.gsfc.nasa.gov

Report message to a moderator

Previous Topic:	complex arithmetic
Next Topic:	FAQ

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:13:40 PDT 2025

Total time taken to generate the page: 0.00517 seconds