comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Contour Smoothing

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Contour Smoothing [message #1988]

Fri, 15 April 1994 07:15

saken
Messages: 6
Registered: November 1993

Junior Member

I've been doing a lot of contour overlays of one image onto another where
the images are a different wavebands, say radio over x-ray. Frequently
the data has large differences in the pixel sizes. Doing the coordinate
transformation and regridding the image is no problem. However, in order
to preserve resolution I tend to "blow-up" the smaller pixels to match the
larger pixel size. Then when I do a contour it tends to a ragged, "blocky"
appearence. I'd like to get a smoother contour, possible some sort of
spline interpolation. The problem is that I can't use the min_curve_surf
routine because my images are too large. I run out of virtual memory,
even with over 200 Mb allocated. Any suggestions?

jon saken

Report message to a moderator

Previous Topic:	Any WWW servers on IDL?
Next Topic:	IDL widget spacing

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 17:39:37 PDT 2025

Total time taken to generate the page: 0.00524 seconds