comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Interploation/extrapolation problem
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Interploation/extrapolation problem [message #19903] Fri, 28 April 2000 00:00
shearerm is currently offline  shearerm
Messages: 11
Registered: July 1999
Junior Member
Hi,

I am interpolating a set of data with scattered x,y,z coords and a
given variable (pressure). I can interpolate the data easily enough
generate surfaces and so forth.

Problem is being scattered data some parts of the regularly spaced
array I generate have been extrapolated rather than interpolated.
Consequently I get some dodgy results round the edge of my volume. Is
there anyway I can exclude the extrapolated part of the array?

I don't really want to shrink the volume I use to exclude these edge
effects as due to the layout of the sensors which provide the data I
wouldn't have much left!

Cheers
Murray



Sent via Deja.com http://www.deja.com/
Before you buy.

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: idl 5.3, problem with plots and mapping environments
Next Topic: Re: accuracy problems

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Oct 10 06:04:11 PDT 2025

Total time taken to generate the page: 1.35873 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software