comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado

Home » Public Forums » archive » Re: Color Printer limitations - Postscript resolution
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend 
Return to the default flat view Create a new topic Submit Reply
Re: Color Printer limitations - Postscript resolution [message #2017 is a reply to message #2006] Thu, 12 May 1994 10:11 Go to previous messageGo to previous message
8015 is currently offline  8015
Messages: 52
Registered: November 1993
Member
In article <2qtlak$im1@spool.cs.wisc.edu>,
Francois Pomport <frp@ssec.wisc.edu> wrote:
>
> Hi,
>
> I am trying to print some filled contour graphics on a color
> printer, but the printer seems to ignore them. Each time IDL warns
...
> Do you
> have any other references for new color printers with an estimated
> price?
>

About a year ago our first effort with IDL and color printers using
postscript was pretty dismal. We blamed it on the printer (Sharp JX-7000
24-bit dye-sub), also. The problem was the time required to print because
the imaging of the postscript was being done with Sun's NeWSPrint software
rather than in the printer's hardware (non-PS printer). Anyway, the solution
was to have IDL output a Sun Raster File using the write_srf procedure in
IDL. The file was then sent to the printer. Processing time was cut from at
least an hour to less than a minute. Priniting time was about five minutes.

If this sounds like a reasonable solution, here is some more info:
Vendor: APUNIX 800/827-8649 (Susan and Vince have been very helpful)
Printer: Sharp JX-7000 24-bit dye-sub printer connected via SCSI
Cost: $8,000
Cost per copy: ~$2 for paper, ribbons, etc.
Output time: 5 minutes once file is created by IDL and spooled to
printer (which takes whatever time is required for your computer to
create and spool a 5 MByte file across the SCSI bus). In our case,
using a Sun IPX, it was about 30 seconds to create the file and a
few seconds to spool the file.

Mike Schienle Hughes Santa Barbara Research Center
mgs@sbjse0.sbrc.hac.com 75 Coromar Drive, M/S B28/87
Voice: (805)562-7466 Fax: (805)562-7881 Goleta, CA 93117
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: Wavelet Routines
Next Topic: color for tvscl

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Nov 28 19:42:32 PST 2025

Total time taken to generate the page: 1.76745 seconds