comp.lang.idl-pvwave archive: archive » Formatted Reads of Arrays

Home » Public Forums » archive » Formatted Reads of Arrays

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Formatted Reads of Arrays [message #20484]

Fri, 30 June 2000 00:00

wcapehar
Messages: 12
Registered: May 1998

Junior Member

For ages I have had to use dummy variables to read formatted data into
an array so that, for example,

for a loop value "i"

readf, 1, rplace, rvalue1, rvalue2, rcode1, rcode2, $
format='(A5,F5.3,I6,2A3)'

place(i) = rplace
value1(i) = rvalue1
value2(i) = rvalue2
rcode1(i) = rcode1
rcode1(i) = rcode2

If all the values were the same type, then I could just read them in as
a big array block and then parse with wildcards. But the mix of
characters and integers in this file requires the personal attention.
Are there any tricks to do this more efficiently or at least drop the
dummy variables?

Thanks much...
Bill

Sent via Deja.com http://www.deja.com/
Before you buy.

Report message to a moderator

[Message index]

		Formatted Reads of Arrays By: wcapehar on Fri, 30 June 2000 00:00
		Re: Formatted Reads of Arrays By: promashkin on Wed, 05 July 2000 00:00

Previous Topic:	Please repost last week mails about fast spline interpolation
Next Topic:	array multiply question

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 06:32:24 PDT 2025

Total time taken to generate the page: 1.12043 seconds