comp.lang.idl-pvwave archive: archive » Re: Multiple plots per page

Home » Public Forums » archive » Re: Multiple plots per page

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Multiple plots per page [message #21]

Wed, 27 February 1991 06:40

edd
Messages: 2
Registered: February 1991

Junior Member

In article <259@locke.water.ca.gov> rfinch@caldwr.water.ca.gov (Ralph Finch) writes:
>
> PV-Wave 3.02 on a Sun 4/260.
>
> I'm trying to make 2 plots on a page, stacked vertically. Page 3-14
> of the Wave manual has exactly what I want:
>
> !p.multi=[0,0,2,0,0]
>
> and it does indeed produce two plots. But, they each only take 1/4 of
> the page, leaving the bottom half of the page blank. Any ideas on how
> to overcome this in an easy fashion? Curiously when output goes to
> the display it works fine, when it goes to the postscript printer it's
> not.

Try re-sizing the plot window of the PostScript device; for example:

WAVE> set_plot, 'PS'
WAVE> device, /inches, xsize=7.0, ysize=10.0,yoffset=0.5,xoffset=1

-----
Ed Doering (edd@iastate.edu)

Report message to a moderator

[Message index]

Re: Multiple plots per page

By: edd on Wed, 27 February 1991 06:40

Previous Topic:	Can procedures be deleted?
Next Topic:	Re: contouring an (r,theta) grid

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Dec 03 08:17:26 PST 2025

Total time taken to generate the page: 1.92760 seconds