comp.lang.idl-pvwave archive: archive » Re: Creating a sphere (Object Graphics)

Home » Public Forums » archive » Re: Creating a sphere (Object Graphics)

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Creating a sphere (Object Graphics) [message #23602 is a reply to message #23595]

Mon, 29 January 2001 10:05

Jason P. Meyers
Messages: 24
Registered: September 2000

Junior Member

OK, I hate editors that don't warn you about breaking long lines. The
following
lines should all be a single line in the IDL procedure. Most are just
comment lines, but two are actual lines of code.

Sorry for any confusions this may have caused!

Jason

"Jason P. Meyers" wrote:
>
>
> PRO JPM_Make_Sphere, n, x=x, y=y, z=z
>

The following pairs of lines should have been left together as one

> ; Parameter: n : array width (must be odd, but we'll make it odd if
> it's not)

> ; Keywords: x,y,z : named variables to contain the 2-D arrays (n x
> 2n-1)

> ; Tweeking the value of m adjusts the spacing of points along the
> z-profile.

> x1 = cos(atan(yy,xx))*(sqrt(abs(1-(1-abs(xx))^m)) >
> sqrt(abs(1-(1-abs(yy))^m)))

> y1 = sin(atan(yy,xx))*(sqrt(abs(1-(1-abs(xx))^m)) >
> sqrt(abs(1-(1-abs(yy))^m)))

Report message to a moderator

[Message index]

		Re: Creating a sphere (Object Graphics) By: Mark Hadfield on Mon, 29 January 2001 11:58
		Re: Creating a sphere (Object Graphics) By: Jason P. Meyers on Mon, 29 January 2001 12:04
		Re: Creating a sphere (Object Graphics) By: Jason P. Meyers on Mon, 29 January 2001 10:05
		Re: Creating a sphere (Object Graphics) By: davidf on Mon, 29 January 2001 09:54

Previous Topic:	Re: Formatting output
Next Topic:	IDL Display under RH7

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 12 02:39:13 PDT 2025

Total time taken to generate the page: 0.40123 seconds