comp.lang.idl-pvwave archive: archive » Re: how to edit a figure in PS form generated by IDL ?

Home » Public Forums » archive » Re: how to edit a figure in PS form generated by IDL ?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: how to edit a figure in PS form generated by IDL ? [message #24179]

Sat, 17 March 2001 12:02

Med Bennett
Messages: 109
Registered: April 1997

Senior Member

I usually import IDL PS figures into CorelDraw if I need to pretty them up -
works great!

web wrote:

> Usually, I hope to insert a figure to a word document. Which form of figure
> should gerenated by IDl? I generate a PS figure which can be printed by
> ghosrview but I donnot know how to inserted to a word document or other edit
> software?

Report message to a moderator

Re: how to edit a figure in PS form generated by IDL ? [message #24269 is a reply to message #24179]

Sun, 18 March 2001 20:46

Joseph B. Gurman
Messages: 31
Registered: April 2000

Member

In article <3AB3C2E3.A1D3B672@indra.com>, mbennett@indra.com wrote:

> I usually import IDL PS figures into CorelDraw if I need to pretty them
> up -
> works great!
>
> web wrote:
>
>> Usually, I hope to insert a figure to a word document. Which form of
>> figure should gerenated by IDl? I generate a PS figure which can be printed by
>> ghosrview but I donnot know how to inserted to a word document or other
>> edit software?

Works in Adobe Photoshop, too, at least on Macs.

Joe Gurman

Report message to a moderator

Previous Topic:	Re: BETTER FONTS
Next Topic:	Linux and 3D graphics hardware support

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 13:44:49 PDT 2025

Total time taken to generate the page: 0.00667 seconds