comp.lang.idl-pvwave archive: archive » Re: Can't get POSTSCRIPT output

Home » Public Forums » archive » Re: Can't get POSTSCRIPT output

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Can't get POSTSCRIPT output [message #2487]

Fri, 08 July 1994 08:12

geomagic
Messages: 22
Registered: November 1993

Junior Member

In article <2vhf7h$77m@mojo.eng.umd.edu> dpal@glue.umd.edu (Debabrata Pal) writes:

> I am trying to get the postscript output of contour plots, but the
> postcript output is truncated. For example, When I view the plot on X
> terminal, it shows ten contour lines, but when I get the PS output, it
> shows only 5 or six lines, also the geometry of the domain, which I
> can see on X terminal, does not appear on the PS output.

Did you use:

device,/close

after executing the commands to make the plot? That's needed to flush
the entire plot to the PS file.

Dan O'Connell
geomagic@seismo.do.usbr.gov
Seismotectonics Group, U.S. Bureau of Reclamation
Denver Federal Center, P.O. Box 25007 D-3611, Denver, CO 80225
"We do custom earthquakes (for food)"
or
"Just more roadkill on the information superhighway"

/\
/ \
/ \ /\ /\
/\ / \ / \ / \ /\ /\/\ /\/\
___/ \ /\/\/\/ \ / \ /\ / \ / \/ \/ \ /\_______
\/ \ / \ / \/ \/ \/
\/ \/

--
Dan O'Connell
geomagic@seismo.do.usbr.gov
Seismotectonics Group, U.S. Bureau of Reclamation

Report message to a moderator

[Message index]

		Re: Can't get POSTSCRIPT output By: geomagic on Fri, 08 July 1994 08:12
		Re: Can't get POSTSCRIPT output By: sjt on Fri, 08 July 1994 01:33

Previous Topic:	WIDGET_CONTROL -- Thanks
Next Topic:	Re: Annotating Radar Images

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 15:23:44 PDT 2025

Total time taken to generate the page: 0.87848 seconds