comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Can't get POSTSCRIPT output
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Can't get POSTSCRIPT output [message #2497] Thu, 07 July 1994 10:49
dpal is currently offline  dpal
Messages: 7
Registered: June 1994
Junior Member
I am trying to get the postscript output of contour plots, but the
postcript output is truncated. For example, When I view the plot on X
terminal, it shows ten contour lines, but when I get the PS output, it
shows only 5 or six lines, also the geometry of the domain, which I
can see on X terminal, does not appear on the PS output.

Can anyone tell me if there is any way to get rid of this problem?

Thanks in advance

Deb

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Aspect Ratio problem
Next Topic: SIMULTANEOUS RUN

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 19:15:57 PDT 2025

Total time taken to generate the page: 0.00523 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software