comp.lang.idl-pvwave archive: archive » Warping surfaces to match control points

Home » Public Forums » archive » Warping surfaces to match control points

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Warping surfaces to match control points [message #25658]

Thu, 05 July 2001 06:52

brad.nelson
Messages: 1
Registered: July 2001

Junior Member

I purchased a magnetic field grid which was generated from poor
navigation data. When we flew through the area again and measured the
magnetic field, many of the anomalies were displaced by km. Does
anyone have an IDL procedure for warping an existing image (my grid
data) to a set of control points (my flight measurements). All of the
warping programs that I have seen rely on two images and a few "this
pixel should be over here" control points. Nowhere have I found an
algorithm that takes many points and matches features. Any
suggestions?

Report message to a moderator

Previous Topic:	Online docs ...
Next Topic:	Re: Inverting colourtable

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 14:56:03 PDT 2025

Total time taken to generate the page: 0.00412 seconds