comp.lang.idl-pvwave archive: archive » Re: Two-page PostScript output

Home » Public Forums » archive » Re: Two-page PostScript output

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Two-page PostScript output [message #28713 is a reply to message #28712]

Thu, 03 January 2002 14:46

David Shadovitz
Messages: 19
Registered: September 2000

Junior Member

That did it! Very intuitive!
Thank you Liam, Dave and Paul.
-David

"Liam E. Gumley" wrote:

> David Shadovitz wrote:
>> So, how do I put a page break into a PostScript file?
>
> Use the ERASE procedure. For example, the following creates a two page
> PS file:
>
> set_plot, 'PS'
> plot, indgen(10)
> erase
> contour, dist(32)
> device, /close

Report message to a moderator

[Message index]

		Re: Two-page PostScript output By: David Shadovitz on Fri, 04 January 2002 09:29
		Re: Two-page PostScript output By: thompson on Thu, 03 January 2002 14:53
		Re: Two-page PostScript output By: David Shadovitz on Thu, 03 January 2002 14:46
		Re: Two-page PostScript output By: Dave Greenwood on Thu, 03 January 2002 13:02
		Re: Two-page PostScript output By: Liam E. Gumley on Thu, 03 January 2002 12:53
		Re: Two-page PostScript output By: Paul van Delst on Thu, 03 January 2002 12:54

Previous Topic:	textbox value on destroy?
Next Topic:	Reporting routines called

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 14:16:53 PDT 2025

Total time taken to generate the page: 0.00205 seconds