comp.lang.idl-pvwave archive: archive » Logical vs. Bitwise boolean operators

Home » Public Forums » archive » Logical vs. Bitwise boolean operators

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Logical vs. Bitwise boolean operators [message #29164]

Fri, 01 February 2002 08:04

James Kuyper
Messages: 425
Registered: March 2000

Senior Member

Fortran has the logical boolean operators .AND., .OR., and .NOT., and I
naively expected the correspondingly named IDL operators to be the same.
However, in IDL, those are bitwise operators, rather than logical ones
(my copy of the manual just calls them 'boolean', without specifying
whether they are logical or bitwise). As a result, the following code
did not do what I expected:

IF (!D.FLAGS AND 8) AND (ratio LE minrat) THEN BEGIN

I can always code around this limitation. The solution I came up with
was to change it to:

IF ((!D.FLAGS AND 8) EQ 8) AND (ratio LE minrat) THEN BEGIN

However, it seems to me that there should be a better way to do this.

Report message to a moderator

[Message index]

Logical vs. Bitwise boolean operators

By: James Kuyper on Fri, 01 February 2002 08:04

Previous Topic:	Re: All I get is gray scale (and IDL 5.5)
Next Topic:	why the output of PS and Screen arenot the same?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 02:00:30 PDT 2025

Total time taken to generate the page: 0.56381 seconds