comp.lang.idl-pvwave archive: archive » Re: suppressing carriage return in PRINT

Home » Public Forums » archive » Re: suppressing carriage return in PRINT

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: suppressing carriage return in PRINT [message #30580 is a reply to message #30579]

Tue, 07 May 2002 14:06

Christopher W. O'Dell is currently offline

Christopher W. O'Dell
Messages: 20
Registered: February 2001

Junior Member

Thanks Kenneth, Paul, and David.

I realized via a simple test that the '($)' format qualifier would
normally solve my problem, but for my particular calculation (involving
a lot of matrix multiplies), for some reason the print procedure gets
"behind" the loop, and if you use that qualifier, nothing gets printed
until after the loop has been completed. I'm willing to bet 5 lattes
that it wouldn't happen in linux/unix. I'm going to try out David's
cool widget program.

In some ways, PASCAL in 1989 was much better than IDL today.

Chris

Report message to a moderator

[Message index]

		Re: suppressing carriage return in PRINT By: Craig Markwardt on Tue, 07 May 2002 18:47
		Re: suppressing carriage return in PRINT By: Paul Van Delst[1] on Tue, 07 May 2002 14:24
		Re: suppressing carriage return in PRINT By: Christopher W. O'Dell on Tue, 07 May 2002 14:06
		Re: suppressing carriage return in PRINT By: David Fanning on Tue, 07 May 2002 10:54
		Re: suppressing carriage return in PRINT By: Kenneth Mankoff on Tue, 07 May 2002 10:33
		Re: suppressing carriage return in PRINT By: Paul Van Delst[1] on Tue, 07 May 2002 10:21
		Re: suppressing carriage return in PRINT By: Christopher W. O'Dell on Tue, 07 May 2002 10:07
		Re: suppressing carriage return in PRINT By: Kenneth Mankoff on Tue, 07 May 2002 09:25
		Re: suppressing carriage return in PRINT By: Christopher W. O'Dell on Fri, 24 May 2002 08:41
		Re: suppressing carriage return in PRINT By: Kenneth Mankoff on Thu, 09 May 2002 07:00

Previous Topic:	Re: EGAD! A common block question.......
Next Topic:	library help -- multiple procedures in one file

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 08:56:19 PDT 2025

Total time taken to generate the page: 0.00739 seconds