comp.lang.idl-pvwave archive: archive » Animating slicer3 output?

Home » Public Forums » archive » Animating slicer3 output?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Animating slicer3 output? [message #30629]

Tue, 14 May 2002 08:16

Rick Matthews
Messages: 9
Registered: May 2002

Junior Member

I am rather new to IDL. I have generated 3-D isosurfaces
using Slicer3. I would like to step through one rotation angle,
saving each image for inclusion in a video.

Is there a way to automate the rotate/save cycle in slicer3?
If not, can someone point me in another direction to achieve the
same result?

I am trying to make a video showing a rotating isosurface.

Thanks.

Rick

--
Rick Matthews matthews@wfu.edu
Department of Physics http://www.wfu.edu/~matthews
Wake Forest University 336-758-5340 (Voice)
Winston-Salem, NC 27109-7507 336-758-6142 (FAX)
USA

Report message to a moderator

[Message index]

		Animating slicer3 output? By: Rick Matthews on Tue, 14 May 2002 08:16
		Re: Animating slicer3 output? By: Paul Sorenson on Tue, 14 May 2002 14:43

Previous Topic:	Re: salt and pepper rush, white noise and Edge detection??
Next Topic:	IDLWAVE 4.13 Release (idlwave.org)

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 08:59:18 PDT 2025

Total time taken to generate the page: 1.19823 seconds