comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » CW_Animate procedure...
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
CW_Animate procedure... [message #32167] Thu, 12 September 2002 10:03
Manish is currently offline  Manish
Messages: 20
Registered: April 2001
Junior Member
Hi all,

I'm writing a program that uses the CW_ANIMATE procedure to animate plots,
then write them to an mpeg file. This is all working fine, but when i come
to write the mpeg (via the save button in the widget), it only writes it at
full speed (frame rate).... :-( I can view it fine at (say) 30% speed,
but saving it as mpeg at that speed is a problem.

I was wondering, is there a way to write the mpeg at a specified % frame
rate, ie 30% of full speed?

Many thanks in advance,

Manish.

--

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Re: Ascii-import
Next Topic: IDL Primer

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Thu Oct 09 14:28:39 PDT 2025

Total time taken to generate the page: 0.15884 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software