comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » slice of 2D surface
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
slice of 2D surface [message #32717] Mon, 28 October 2002 11:24
Artifex138 is currently offline  Artifex138
Messages: 2
Registered: October 2002
Junior Member
My data is given by x,y,z coords (i.e. 3 independent vectors). I've
made a 2D surface using the surface func. How can I take slices of
the resulting surface? I'm not able to use the slicer3 func since
apparently it only works for true 3D volumes. Thanks.

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: slice of 2D surface
Next Topic: Re: Lossless JPG Decompression

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 15:53:34 PDT 2025

Total time taken to generate the page: 0.00566 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software