comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Re: Slicing Question

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Slicing Question [message #35238]

Fri, 23 May 2003 07:48

Karl Schultz
Messages: 341
Registered: October 1999

Senior Member

"MC" <markchan@shaw.ca> wrote in message
news:n5gza.46088$ro6.1347967@news2.calgary.shaw.ca...
> I have a cube, say 100X100X100. Each cell contains a different number.
>
> What is the best way to take a slice out of it in angles other than 0 or
90
> degrees without loosing the content of the cell?
>
> Note: If I cut the cube using a plane at, say 30 degree about the z-axis,
> the cut surface will contain portions of some cells. What will be best
> approach to get such a slice while preserving the properties of each cell,
> including partial cells cut by this plane?

EXTRACT_SLICE with the SAMPLE kw might do what you want.

Report message to a moderator

Previous Topic:	Newbie-Alert: Plotting 3D data in IDL
Next Topic:	Re: FFT function,

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 14:55:55 PDT 2025

Total time taken to generate the page: 0.00494 seconds