comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Slicing Question
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Slicing Question [message #35247] Thu, 22 May 2003 19:56
MC is currently offline  MC
Messages: 50
Registered: September 1996
Member
I have a cube, say 100X100X100. Each cell contains a different number.

What is the best way to take a slice out of it in angles other than 0 or 90
degrees without loosing the content of the cell?

Note: If I cut the cube using a plane at, say 30 degree about the z-axis,
the cut surface will contain portions of some cells. What will be best
approach to get such a slice while preserving the properties of each cell,
including partial cells cut by this plane?

Thanks,
MC

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Help with HDF Format
Next Topic: problem with idldoc

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 17:36:45 PDT 2025

Total time taken to generate the page: 0.00510 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software