comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Reading and writing DXF files
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Reading and writing DXF files [message #35407] Wed, 28 May 2003 06:45
Norbert Hahn is currently offline  Norbert Hahn
Messages: 46
Registered: May 2003
Member
Hi,

I need to read and possibly write DXF files (AutoCAD) from within IDL.
Is there some routine that extracts geometry information from DXF files
around? Are there better formats suited to get 3D geometry from AutoCAD
to IDL (and back) ?

Norbert

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Webcam and serial control
Next Topic: Re: Reading and writing DXF files

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Oct 10 04:31:29 PDT 2025

Total time taken to generate the page: 1.99436 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software