comp.lang.idl-pvwave archive: archive » IDLWAVE convert end to endfor?

Home » Public Forums » archive » IDLWAVE convert end to endfor?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

IDLWAVE convert end to endfor? [message #35220]

Tue, 27 May 2003 12:19

psisquared01
Messages: 7
Registered: December 2002

Junior Member

Newbie question... In looking back over the IDLWAVE user manual since
installing v.5.0 I noticed that in the tutorial it says that END is
converted to ENDFOR automatically for a for loop. My IDLWAVE has never
done this, in version 4.16 or the new 5.0. Is there a setting I can set
to have this done? Thanks.

Report message to a moderator

Re: IDLWAVE convert end to endfor? [message #35416 is a reply to message #35220]

Tue, 27 May 2003 17:25

JD Smith
Messages: 850
Registered: December 1999

Senior Member

On Tue, 27 May 2003 12:19:02 -0700, Rob wrote:

> Newbie question... In looking back over the IDLWAVE user manual since
> installing v.5.0 I noticed that in the tutorial it says that END is
> converted to ENDFOR automatically for a for loop. My IDLWAVE has never
> done this, in version 4.16 or the new 5.0. Is there a setting I can set
> to have this done? Thanks.

Yes, it's not on by default. You have to configure the variable
idlwave-expand-generic-end. The easiest way is to M-x customize-variable
it. Or you can examine the ".emacs" sections of the manual which shows
this being set with other settings in your customization file. That one
saves me lots of times, especially when I forget where I am in some
deeply nested if..then..else..if block.

JD

Report message to a moderator

Previous Topic:	Minimization of deviations from multiple curve fits.
Next Topic:	Is there a simple way to plot field lines?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 03:43:04 PDT 2025

Total time taken to generate the page: 0.39939 seconds