comp.lang.idl-pvwave archive: archive » Re: IDLWAVE and commenting out sections

Home » Public Forums » archive » Re: IDLWAVE and commenting out sections

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: IDLWAVE and commenting out sections [message #35557]

Fri, 20 June 2003 11:24

paul wisehart
Messages: 28
Registered: December 2002

Junior Member

On Fri, 20 Jun 2003 10:33:36 -0700, JD Smith <jdsmith@as.arizona.edu> wrote:
> Thanks. Just mark it as described and use [C-c ;]. The same command
> uncomments commented sections. You might also find the various
> commands to mark and move among sub-blocks and program units useful:
>
> M-C-h Mark sub-program
> IDLWAVE->Mark->Block Mark block
> IDLWAVE->Mark->Header Mark the header
> M-C-n Move to end of next block (if, case, etc.)
> M-C-p Move the beginning of the previous block
> M-C-d Move down one nested block before point
> C-- M-C-d Move down one nested block before point
> M-C-u Move up to the top of current enclosing block
> C-- M-C-u Move up to the end of the current enclosing block
> M-C-a Move to beginning of current sub-program
> M-C-e Move to end of current sub-program

Thanks!

I am decreasing my key-strokes rapidly.
Soon, I will not have to actually type anything to program.

--
paul \ /
wisehart >/
<//////$>
|\|\|\

Report message to a moderator

[Message index]

		Re: IDLWAVE and commenting out sections By: paul wisehart on Fri, 20 June 2003 11:24
		Re: IDLWAVE and commenting out sections By: JD Smith on Fri, 20 June 2003 10:33

Previous Topic:	spherical gridding
Next Topic:	MPEG

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 14:11:55 PDT 2025

Total time taken to generate the page: 0.00423 seconds