comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » question regarding "surface" command
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
question regarding "surface" command [message #357] Wed, 20 May 1992 18:13
srf is currently offline  srf
Messages: 1
Registered: May 1992
Junior Member
Is there a way to do a surface plot but have the lines drawn only along
the horizontal x-axis, rather than along the line of sight (as results
from setting the HORIZONTAL keyword)? In other words, I want to see the
same result you get from using "threed" but with three axes instead of two.

please email me:
--
---
Steve Feinstein
MIT Lincoln Laboratory, 29 Hartwell Ave., Lexington, MA 02173
srf@juliet.ll.mit.edu, Office tel 617-981-4017, Fax 617-981-0632
USmail: 32 Greenwood Road, Sharon, MA 02067, Home tel: 617-784-2242

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Solution: QMS driver under VMS and IDL 2.3
Next Topic: Re: xdemo crashes twm in IDL 2.3

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Oct 11 16:14:43 PDT 2025

Total time taken to generate the page: 0.72527 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software