comp.lang.idl-pvwave archive: archive » Re: Mesh decimate for DXF data formats

Home » Public Forums » archive » Re: Mesh decimate for DXF data formats

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Mesh decimate for DXF data formats [message #37297 is a reply to message #37292]

Thu, 11 December 2003 10:48

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Neil writes:

> You can use Mesh Decimate to reduce the number of
> vertices, but when i tried it for an aircraft it took an important
> artifact away - the wings.

This is just *one* of the reasons I love working with
computer software. :-)

Cheers,

David

--
David W. Fanning, Ph.D.
Fanning Software Consulting, Inc.
Phone: 970-221-0438, E-mail: david@dfanning.com
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Toll-Free IDL Book Orders: 1-888-461-0155

Report message to a moderator

[Message index]

		Re: Mesh decimate for DXF data formats By: Karl Schultz on Thu, 11 December 2003 12:21
		Re: Mesh decimate for DXF data formats By: David Fanning on Thu, 11 December 2003 10:48

Previous Topic:	Re: Porting to VM
Next Topic:	rebinning data on new time samples without loops?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat May 23 08:56:25 PDT 2026

Total time taken to generate the page: 1.99974 seconds