comp.lang.idl-pvwave archive: archive » Re: color PS output error??

Home » Public Forums » archive » Re: color PS output error??

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: color PS output error?? [message #37939 is a reply to message #37938]

Sun, 08 February 2004 18:19

shson
Messages: 8
Registered: August 2003

Junior Member

Dear BOB,

Thank you for your comment.
However, Set_Plot doesn't allow '/Color'.
How did you do that?

Thanks.

Son.

> Dear Son,
> add "/color" to the device call (immediately after your set_plot,'ps' command).
>
> Cheers,
> bob
>
> PS mom sends her love. :)
>
> From the help:
> The DEVICE procedure provides device-dependent control over the current graphics device (as set by the SET_PLOT routine). The IDL
> graphics procedures and functions are device-independent. That is, IDL presents the user with a consistent interface to all devices.
> However, most devices have extra abilities that are not directly available through this interface. DEVICE is used to access and
> control such abilities. It is used by specifying various keywords that differ from device to device.
>
> See IDL Graphics Devices for a description of the keywords available for each graphics device.
>
> Syntax
> Note
> ------------------------------------------------------------ --------------
>
> Each keyword to DEVICE is followed by the device(s) to which it applies.
>
> [, /COLOR{PCL, PS}]

Report message to a moderator

[Message index]

		Re: color PS output error?? By: David Fanning on Sun, 08 February 2004 20:25
		Re: color PS output error?? By: shson on Sun, 08 February 2004 18:19
		Re: color PS output error?? By: R.G. Stockwell on Sun, 08 February 2004 09:20

Previous Topic:	color PS output error??
Next Topic:	Using IDL in a ultiprocessor real-time system ?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 22:31:32 PDT 2025

Total time taken to generate the page: 0.00580 seconds