comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » envi_avhrr_warp_doit: How to set corners of the warped image?
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
envi_avhrr_warp_doit: How to set corners of the warped image? [message #38893] Wed, 07 April 2004 00:34
wl2776 is currently offline  wl2776
Messages: 13
Registered: February 2004
Junior Member
After performing this routine I have the warped image in a projection,
but its corners are not visible because they are left outside.

How to make the area of the warped image a bit greater in order to see
image corners?

Thank you!

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Re: automated file input possible?
Next Topic: GUI procedure to function

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Oct 10 16:24:31 PDT 2025

Total time taken to generate the page: 0.72019 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software