comp.lang.idl-pvwave archive: archive » Re: implementing pre pritten routines

Home » Public Forums » archive » Re: implementing pre pritten routines

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: implementing pre pritten routines [message #39850]

Sat, 19 June 2004 21:38

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Lafoz writes:

> I have two contours (images) one lies above the other one, and I'm
> trying to connect the two to form mountain looking thing. I hope that
> clarifies it a bit.

Ah, right. Forget that INTERPOLATE program you were given. :-)

Put your contours into an IDLgrROIGroup object, then use
the ComputeMesh method to create your surface mesh.

The steps are outlined in this article, which demonstrates
how to build a 3D surface from 2D contours:

http://www.dfanning.com/graphics_tips/mesh.html

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/

Report message to a moderator

[Message index]

		Re: implementing pre pritten routines By: David Fanning on Sat, 19 June 2004 21:38
		Re: implementing pre pritten routines By: aontman1 on Sat, 19 June 2004 19:17
		Re: implementing pre pritten routines By: David Fanning on Sat, 19 June 2004 14:47

Previous Topic:	implementing pre pritten routines
Next Topic:	Re: Ternary diagrams

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Dec 03 05:58:28 PST 2025

Total time taken to generate the page: 1.99808 seconds