comp.lang.idl-pvwave archive: archive » Re: Arrays with NaN values

Home » Public Forums » archive » Re: Arrays with NaN values

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Arrays with NaN values [message #41286 is a reply to message #41277]

Sat, 02 October 2004 23:30

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Julio writes:

> I need to manipulate arrays with some NaN values inside. How can I put
> zero values in the place of the NaN values??

Here is an article that describes how to find them, so
you can change them:

http://www.dfanning.com/tips/check_nan.html

Cheers,

David

--
David W. Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http:/www.dfanning.com/
Phone: 970-221-0438, IDL Book Orders: 1-888-461-0155

Report message to a moderator

[Message index]

		Re: Arrays with NaN values By: Mark Hadfield on Mon, 04 October 2004 16:58
		Re: Arrays with NaN values By: David Fanning on Mon, 04 October 2004 13:35
		Re: Arrays with NaN values By: julio on Mon, 04 October 2004 10:08
		Re: Arrays with NaN values By: David Fanning on Sun, 03 October 2004 22:22
		Re: Arrays with NaN values By: julio on Sun, 03 October 2004 13:36
		Re: Arrays with NaN values By: David Fanning on Sat, 02 October 2004 23:30
		Re: Arrays with NaN values By: Paul Van Delst[1] on Tue, 05 October 2004 09:13

Previous Topic:	Re: Map_grid options
Next Topic:	General 3D graphics advise required

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Dec 02 13:08:48 PST 2025

Total time taken to generate the page: 0.19291 seconds