comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » How to set the 50 pins expansion header to 5.0V from default 3.3V
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
How to set the 50 pins expansion header to 5.0V from default 3.3V [message #42183] Thu, 06 January 2005 06:53
gordanic2003 is currently offline  gordanic2003
Messages: 1
Registered: January 2005
Junior Member
Hello everyone,

The 50 pins on the expansion header on Celoxica RC100 board is 3.3V by
default.

How to change it to 5.0V using Handel C DK3? I know it has something to
do with the 'standard' command but how do I actually use it?
Thank you.

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: double tick marks
Next Topic: Re: double tick marks

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 18:41:21 PDT 2025

Total time taken to generate the page: 0.00501 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software