comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » error_state.code
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
error_state.code [message #43243] Thu, 24 March 2005 06:18
Bringfried Stecklum is currently offline  Bringfried Stecklum
Messages: 75
Registered: January 1996
Member
Hello,

back in the times of 5.6 I wrote a program which accepts input from /dev/stdin. I used
the on_ioerror command to test the end of the input, i.e. a ^D at the prompt yielded the
!error_state.code of -236 which was used to terminate the input. I noticed that this piece of
software did not work anymore with IDL 6.1. The reason is that the error_state codes obviously
differ: EOF is now -265. Can a brave soul point me to the section of the documentation where
these codes are summarized (as well as the changes). I have not found that yet.

with kind regards,

Bringfried Stecklum

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Little CREATE_STRUCT issue
Next Topic: Re: error_state.code

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Oct 11 22:08:34 PDT 2025

Total time taken to generate the page: 1.36661 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software