comp.lang.idl-pvwave archive: archive » interpolate over bad pixels

Home » Public Forums » archive » interpolate over bad pixels

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

interpolate over bad pixels [message #44560]

Mon, 27 June 2005 15:26

Em
Messages: 2
Registered: June 2005

Junior Member

I was hoping you could help me out here. I have a set of images where a
few pixels are bad, or set to "NaN". Can you tell me how I can
interpolate over these bad pixels, using preferrably a spline or cubic
interpolation? The region with bad pixels is usually around 3-8 pixels
in diameter on a 1024x1024 image. Is there a routine that takes the
image and a list of the indices of bad pixels, and outputs an
interpolated image?

I have looked at the convol routine, and tri_surf. If these do what I
need them to do, I have not figured out how to use them...

Thanks,
Em

Report message to a moderator

[Message index]

interpolate over bad pixels

By: Em on Mon, 27 June 2005 15:26

Previous Topic:	MPFIT2DPEAK with constraints
Next Topic:	backing store

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 15:49:22 PDT 2025

Total time taken to generate the page: 1.35865 seconds