comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Re: how to call dll

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: how to call dll [message #44845 is a reply to message #44752]

Sun, 17 July 2005 15:20

Mark Hadfield
Messages: 783
Registered: May 1995

Senior Member

rzsh5 wrote:
> Actually, I have wrote a IDL program and
> merged this IDL program into visual basic. But when I did this, an
> error occurs, that is: synatx error about NCDF_OPEN. which shows the
> program can't load ncdf_open function. And when I remove the
> idl_netcdf.dll from bin\bin.x86, same errors occur in IDL. So, I want
> to try whether I can use these functions from idl_netcdf.dll directly.

What do you mean by "wrote an IDL program and merged this IDL program
into Visual Basic"?

--
Mark Hadfield "Kei puwaha te tai nei, Hoea tahi tatou"
m.hadfield@niwa.co.nz
National Institute for Water and Atmospheric Research (NIWA)

Report message to a moderator

[Message index]

		Re: how to call dll By: Haje Korth on Fri, 15 July 2005 05:19
		Re: how to call dll By: rzsh5 on Fri, 15 July 2005 00:03
		Re: how to call dll By: rzsh5 on Fri, 15 July 2005 00:02
		Re: how to call dll By: Mark Hadfield on Thu, 14 July 2005 22:28
		Re: how to call dll By: Mark Hadfield on Sun, 17 July 2005 15:20

Previous Topic:	Re: how to define a struct header of fixed length in IDL
Next Topic:	programming course

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Dec 03 11:01:32 PST 2025

Total time taken to generate the page: 1.52519 seconds