comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » How to control plotting region when using !p.multi & X11 ???
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
How to control plotting region when using !p.multi & X11 ??? [message #4598] Fri, 02 June 1995 00:00
mcarter is currently offline  mcarter
Messages: 1
Registered: June 1995
Junior Member
Why is text 'drawn' at (0.0, 1.0) not displayed on an 'X' display but
comes out fine using 'PS'??? Bringing it down to (0.0, 0.98) works
but then the title of my plot is garbled by the text because the title
is drawn right at the top. The POSITION keyword is a fix for 1
plot/page, but screws up the use of !p.multi.

Suggestions???

Thanks,

Michael

| Michael J. Carter Space Data Systems (NIS-3) |
| mcarter@lanl.gov Los Alamos National Laboratory |

--
| Michael J. Carter Space Data Systems (NIS-3) |
| mcarter@lanl.gov Los Alamos National Laboratory |

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: MAP_SET Aspect Ratio
Next Topic: TLB_GET_SIZE - strangeness!

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 15:22:55 PDT 2025

Total time taken to generate the page: 0.00518 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software