comp.lang.idl-pvwave archive: archive » converting map projections using ENVI

Home » Public Forums » archive » converting map projections using ENVI

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: converting map projections using ENVI [message #50158 is a reply to message #50106]

Fri, 15 September 2006 13:54

James Kuyper
Messages: 425
Registered: March 2000

Senior Member

surajchem@hotmail.com wrote:
> I did not write any code i just use ENVI software to do the conversion,
> i had obtain the data from any ftp site where they mention about using
> ENVI software to use it.

Sorry - I read your message too quickly, and didn't notice that it was
ENVI, rather than code that you wrote, which produced this message.
Without knowing which line of code is failing, it's going to be
difficult to figure out which array has the wrong dimensions.

At the very least, could you provide an explanation of the exact steps
you took, including the values of all relevant projection parameters
that you set?

Report message to a moderator

[Message index]

		converting map projections using ENVI By: surajchem on Wed, 13 September 2006 12:57
		Re: converting map projections using ENVI By: James Kuyper on Fri, 15 September 2006 13:54
		Re: converting map projections using ENVI By: surajchem on Mon, 18 September 2006 08:46

Previous Topic:	calculating rotations from a transformation matrix
Next Topic:	Re: Yo Mama....IDL Humor Re: Newsgroup Decorum

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Nov 29 22:12:05 PST 2025

Total time taken to generate the page: 0.00794 seconds