comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Opening a .isv file
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Opening a .isv file [message #50679] Fri, 13 October 2006 08:09
K. Bowman is currently offline  K. Bowman
Messages: 330
Registered: May 2000
Senior Member
The ability to save the iTools state in a .isv file is extremely useful.

To open a .isv file, however, one must start an iTool, then use the File...Open
menu item interactively to navigate to the .isv file to open it.

Is there a simple command-line way to do this, such as

isv_open, filename

where filename is the path to the file?

Ken Bowman

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Findfile in large directories
Next Topic: Re: Reading CDF files on a Mac

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 11:39:51 PDT 2025

Total time taken to generate the page: 0.01163 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software