comp.lang.idl-pvwave archive: archive » Re: Problem with compiling ENVI-BATCH routine

Home » Public Forums » archive » Re: Problem with compiling ENVI-BATCH routine

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Problem with compiling ENVI-BATCH routine [message #51176]

Wed, 08 November 2006 07:10

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Josip Krizan writes:

> I thought so, but why then I can access ENVI_OPEN_FILE, ENVI_DOIT, .... and
> others?

I'm not sure I understand this question. You can access
them because after you restore the save files, these routines
exist in your IDL session as if you had compiled them.

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: Problem with compiling ENVI-BATCH routine By: David Fanning on Wed, 08 November 2006 07:10
		Re: Problem with compiling ENVI-BATCH routine By: Josip Krizan on Wed, 08 November 2006 06:50
		Re: Problem with compiling ENVI-BATCH routine By: David Fanning on Wed, 08 November 2006 06:04

Previous Topic:	Concatenate arrays of different dimensions
Next Topic:	Re: iTools: lines too thick to publish?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 23:50:51 PDT 2025

Total time taken to generate the page: 0.56012 seconds