comp.lang.idl-pvwave archive: archive » Re: Is there any maximum number of lines for a procedure?

Home » Public Forums » archive » Re: Is there any maximum number of lines for a procedure?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Is there any maximum number of lines for a procedure? [message #52624 is a reply to message #52621]

Mon, 19 February 2007 11:21

Jean H.
Messages: 472
Registered: July 2006

Senior Member

rusben wrote:
> Is there any maximum number of lines for a procedure?
>
> I'm asking for this question because I've compiled a large procedure
> (650 lines) in idl 6.3 and syntax errors ocurred.
>
> I've tried to compile the error lines separately and they worked out,
> but in the whole function they crash.
>
>
> Fanning, how about holydays in Madridï¿½?
>
> thanks, IDL gurus ! ! !
>
> from GRAHI headquarters -- hydrologic and radar research systems
>

Rusben, you might want to put a special attention on the 1st error... if
you make a mistake, let's say you write END IF instead of ENDIF, you
will have several errors later in your file... like at the declaration
of your pro/function.

Jean H.

Report message to a moderator

[Message index]

		Re: Is there any maximum number of lines for a procedure? By: Carsten Lechte on Mon, 19 February 2007 14:49
		Re: Is there any maximum number of lines for a procedure? By: Jean H. on Mon, 19 February 2007 11:21
		Re: Is there any maximum number of lines for a procedure? By: rusben on Mon, 19 February 2007 11:11
		Re: Is there any maximum number of lines for a procedure? By: David Fanning on Mon, 19 February 2007 10:51

Previous Topic:	Is there any maximum number of lines for a procedure?
Next Topic:	How does auxdata in mesh_surfacearea work?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 00:57:48 PDT 2025

Total time taken to generate the page: 0.79635 seconds