comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Fitting 3D spline to an x,y,z point cloud
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Fitting 3D spline to an x,y,z point cloud [message #52895] Thu, 08 March 2007 00:41
Thomas Launey is currently offline  Thomas Launey
Messages: 25
Registered: September 1999
Junior Member
Hi all,

I need to fit a spline to a 3D point cloud, where the points are
basically along a smooth curve, with a bit of noise. I have always
succesfully used MPfit for all my 2D fitting but here, I am not sure
where to start. Any help or pointers would be most welcome.
Thanks,
Thomas

Thomas LAUNEY, PhD
Lab. for Memory & Learning, RIKEN Brain Science Institute. Wako-shi,
Japan

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Re: mapping volume data
Next Topic: strange behaviour of ladfit - known?

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 20:06:40 PDT 2025

Total time taken to generate the page: 0.44283 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software