comp.lang.idl-pvwave archive: archive » Fitting 3D spline to an x,y,z point cloud

Home » Public Forums » archive » Fitting 3D spline to an x,y,z point cloud

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Fitting 3D spline to an x,y,z point cloud [message #52895]

Thu, 08 March 2007 00:41

Thomas Launey
Messages: 25
Registered: September 1999

Junior Member

Hi all,

I need to fit a spline to a 3D point cloud, where the points are
basically along a smooth curve, with a bit of noise. I have always
succesfully used MPfit for all my 2D fitting but here, I am not sure
where to start. Any help or pointers would be most welcome.
Thanks,
Thomas

Thomas LAUNEY, PhD
Lab. for Memory & Learning, RIKEN Brain Science Institute. Wako-shi,
Japan

Report message to a moderator

[Message index]

Fitting 3D spline to an x,y,z point cloud

By: Thomas Launey on Thu, 08 March 2007 00:41

Previous Topic:	Re: mapping volume data
Next Topic:	strange behaviour of ladfit - known?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Nov 30 06:12:22 PST 2025

Total time taken to generate the page: 0.31848 seconds