comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Re: Segmentation fault: IDL Version 6.3 (linux x86 m32)+Debian SID
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Re: Segmentation fault: IDL Version 6.3 (linux x86 m32)+Debian SID [message #54538] Tue, 26 June 2007 23:03 Go to next message
Li.Huimin is currently offline  Li.Huimin
Messages: 6
Registered: October 2006
Junior Member
Thank you very much, it works now.
On 6 27 , 11 35 , David Fanning <n...@dfanning.com> wrote:
> HM Li writes:
>> When I run the iplot or other itools commands, it crashs:
>
> Sounds like this old problem rearing its head again:
>
> http://www.dfanning.com/misc_tips/segfault.html
>
> Cheers,
>
> David
> --
> David Fanning, Ph.D.
> Fanning Software Consulting, Inc.
> Coyote's Guide to IDL Programming:http://www.dfanning.com/
> Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

Re: Segmentation fault: IDL Version 6.3 (linux x86 m32)+Debian SID [message #54540 is a reply to message #54538] Tue, 26 June 2007 20:35 Go to previous messageGo to next message
David Fanning is currently offline  David Fanning
Messages: 11724
Registered: August 2001
Senior Member
HM Li writes:

> When I run the iplot or other itools commands, it crashs:

Sounds like this old problem rearing its head again:

http://www.dfanning.com/misc_tips/segfault.html

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

Re: Segmentation fault: IDL Version 6.3 (linux x86 m32)+Debian SID [message #54652 is a reply to message #54540] Sat, 30 June 2007 11:02 Go to previous message
George N. White III is currently offline  George N. White III
Messages: 56
Registered: September 2000
Member
On Tue, 26 Jun 2007, David Fanning wrote:

> HM Li writes:
>
>> When I run the iplot or other itools commands, it crashs:
>
> Sounds like this old problem rearing its head again:
>
> http://www.dfanning.com/misc_tips/segfault.html

I'm running Fedora 7 now. The distribution doesn't include an old
libX11. Many FC6 binaries work on F7 since the toolchain is
basically unchanged, so I forced the install of the FC6 libX11.
This worked until the first upgrade, at which point the package manager
just deleted everything that depends on X11.

I installed the IDL 6.4 demo but it causes a hard crash when I try to use
graphics. I'm rebuilding gdl now.

--
George N. White III <aa056@chebucto.ns.ca>

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: Re: MI5 Persecution: Goldfish and Piranha 29/9/95 (557)
Next Topic: Re: distributed IDL or IDL on a Grid

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 19:17:30 PDT 2025

Total time taken to generate the page: 0.01415 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software